Dishwasher Wheel Support Stock Number: ES185033

Overall rating

• Pete Brighton
  5.0 out of 5

  Why didn't I do this sooner.. 07 May 2015

  The old wheels kept falling off every time you moved the upper tray - a bit of a pain. These parts are original parts so fitted straight from the wrapper, nice and easy, but beware that the bits they screw onto can drop down behind the inner wall of the machine (Zanussi DW925) so be carefull, and don't loose the rubber o rings behind - they're expensive to replace. Otherwise a nice simple job.

  Ease of fitting	4.0 out of 5
  Quality	5.0 out of 5
  Value	5.0 out of 5

• Df
  5.0 out of 5

  Does exactly what it says 19 March 2015

  I took the advice of some other reviewers and only fully undid one screw at a time -loosening the other allowed me to swing one end around while attaching the new set of wheels.

  Ease of fitting	4.0 out of 5
  Quality	4.0 out of 5
  Value	3.0 out of 5

• bushbaby Bolton
  4.0 out of 5

  Useful replacement, a little tricky to fit 03 February 2015

  The wheels on these supports gradually wear with use, and replacing makes the rack run much more easily. You will normally need a set of four, which makes the set a little expensive. I have an important tip to help with fitting. DON'T undo both screws at once. I did this and the sockets disappeared into the body of the washer! Instead, Loosen one screw but make sure it still catches the socket (the two sockets are connected inside the body), then remove the other screw and twist the old support to one side. Screw one side of the new support in a little way before completely removing the old one - three hands would help with this operation.

  Ease of fitting	3.0 out of 5
  Quality	4.0 out of 5
  Value	3.0 out of 5

• kenhath Charmouth
  4.0 out of 5

  Does the job 12 November 2014

  Difficult to fit. Not fault of product. Machine design fault.

  Ease of fitting	2.0 out of 5
  Quality	4.0 out of 5
  Value	4.0 out of 5

• Anonymous lichfield
  5.0 out of 5

  quick delivery easy to replace 05 October 2014

  Easy to fit making the basket safe again and pulling out smoothly

  Ease of fitting	5.0 out of 5
  Quality	5.0 out of 5
  Value	5.0 out of 5

• ord stoke on trent
  5.0 out of 5

  good 04 September 2014

  thank you very much needed my husband fitted them took him all of 2 mins said they were easy fit now my dishwasher id great defo come back to you thank you

  Ease of fitting	5.0 out of 5
  Quality	5.0 out of 5
  Value	5.0 out of 5

• no nickname birmingham
  5.0 out of 5

  good quality 20 June 2014

  prompt service will use again, cheap prices, good packagine no damage

  Ease of fitting	5.0 out of 5
  Quality	5.0 out of 5
  Value	5.0 out of 5

• billy essex essex
  4.0 out of 5

  REPLACEMENT 18 June 2014

  I have had the Zamussi dishwasher sixteen years: the plastic wheels become brittle with the heat of the water and with use sliding the metal runners back and forth, the flanges on the plastic wheels break off. I feel the design could be improved if the wheels were in a more substantial material. I found fitting was reasonably easy. I think these brackets and wheels are manufactured very cheap and are well over priced. It should be noted that these are sold in single pairs and four sets are required. The other wheels used to fit the top runners are sold in a set of the eight required. I would add that with a car being serviced the mechanic would not fit just one spark plug: you need the full set.

  Ease of fitting	4.0 out of 5
  Quality	3.0 out of 5
  Value	1.0 out of 5

• Anonymous South West
  3.0 out of 5

  Does the job, but not cheap enough 24 May 2014

  My dishwasher requires 4 of these for the upper tray support, making it quite an expensive repair. It is a pity that I couldn't buy just the plastic wheels, as the rest of the fitting hadn't failed.

  Ease of fitting	4.0 out of 5
  Quality	3.0 out of 5
  Value	2.0 out of 5

• GH
  4.0 out of 5

  Dishwasher back on the rails 29 April 2014

  Having already bought upper basket wheel kit and been happy with result , thought I'd try the side panel wheel kit. With some expert help from an E-spares adviser, I got the correct part at a much cheaper price than advertised originally on screen. Fitted within 30 mins and I am no expert. Satisfied customer

  Ease of fitting	5.0 out of 5
  Quality	5.0 out of 5
  Value	4.0 out of 5

Ratings-Only Reviews