Dishwasher Instantaneous Water Heating Element Stock Number: ES1065955
Genuine spare part for select models of Bosch, Neff and Siemens dishwashers
Cycle carries on indefinitely as, I guess the washer is waiting to reach temperature. How do I check if it is probe, heater element or controller?
- This problem could be as a result of a faulty power module. There has been a product recall on this for some models. Contact 0800 023 4881 with your full model number and serial number to check if your appliance is subject to the recall as the module may be replaced free of charge if it is one affected.
It will complete the cold rinse cycle but cuts out part way through the hot cycles, I therefore suspect that it may be comething to do with the heating element or the switch mechanism that switches on the heating element. When it cuts out it trips the electricity supply.
-
Rory at eSpares says...
Hi Nige, seeing as the dishwasher is tripping the mains fuse, there's obviously a surge happening at some point in the dishwasher's electronic circuit. I'd recommend checking the PCB, element and thermostat with a multimeter to see which part is damaged.
water reaching one of the spray arms only. took of arms cleaned them inspected them they seem to be o k. looked at the heater element cleaned it put back together , it started spraying to both arms but after a bit went back to one arm.run machine without spray arms and water comes out of one hole only from the heater element, water does get hot but only after about 10 mins , dishwasher is a bosch
-
Rory at eSpares says...
Hi, I can't tell you for sure what's causing just the one spray arm to malfunction. I'd recommend making sure all tubing leading from the water inlet to the spray arm is aligned. Check for blockages too. With regard to the water not heating up, I'd say if it's not a problem with the element, it could well be the motor is not functioning properly and not pumping all the water it should be. Hope this helps!
Will this unit be the problem if no water is spraying from the top spra arm?
-
Rory at eSpares says...
Hi Cchristof Without actually seeing your dishwasher, it is impossible to tell what is causing this problem. What I would advise is talking to your local dishwasher specialist and they should be able to diagnose the problem for you. And that's where we come in! With thousands of dishwasher spares, we're bound to have the part for you.
Bosch Classixx Electronic. Wash cycles have gone cold. Did a continuity test in situ with leads removed and got a reading. Not an electrician. New part expensive at 120 quid so exploring all avenues of possibility before replacing. 2005 model but plate unreadable.
Will this part fit my appliance?
Check Now