Electrolux Tumble Dryer Half Brick Vent Kit for EDC 565 E Stock Number: ES509980

Overall rating

• James North Wales
  5.0 out of 5

  Easy to install 12 April 2021

  Value for money and so easy to install. No more keeping the door open while using the tumble dryer.

  Ease of fitting	5.0 out of 5
  Quality	5.0 out of 5
  Value	5.0 out of 5

• W.M.
  5.0 out of 5

  One brick vent kit 28 March 2017

  the kit was fit for purpose. it was an excellent fit to flexible hose that I bought to go with it and I was completely satisfied

  Ease of fitting	5.0 out of 5
  Quality	5.0 out of 5
  Value	5.0 out of 5

• MS lancashire
  5.0 out of 5

  Sturdy and useful, saves a lot of drill burn 01 July 2016

  I hate drilling through brick. It jangles my nerves. This kit removed the need to drill with a holesaw through the outer brick skin of my house. All you need to do is identify and remove half a brick - not even a full brick, just a half. Drill out the mortar and use a bolster and (in my case) a handy geologist's hammer to weaken a line down th chosen full brick, then one good wallop with a lump hammer at the looser end will crack it fully ready for removal. And you can cut through the inner aerated block layer with a knife n fork. I used builders foam to stabilise the whole kit in position, again avoiding the need to drill.

  Ease of fitting	5.0 out of 5
  Quality	5.0 out of 5
  Value	5.0 out of 5

• JohnL Cumbria
  5.0 out of 5

  A neat job 22 February 2016

  It's actually a half brick vent but it does the job very well and gives a neat, professional finish. Choose a joint in the brickwork to make drilling out easier and arm yourself with a tube of silicone filler to make good any gaps. It would have been even better value if the kit had come supplied with a venting hose.

  Ease of fitting	5.0 out of 5
  Quality	4.0 out of 5
  Value	3.0 out of 5

• Anonymous Staffordshire
  5.0 out of 5

  Does exactly what I needed 07 November 2014

  Was looking for a decent tumble dryer vent to install easily and with less fuss than smashing a large unsightly round hole through brick and breeze block. This product fitted the bill perfectly, simply remove half a brick outside, chisel out a same sized hole behind and cut out the entry through the plaster board. Easy enough to install by a modest DIY'er. End result looks neat and tidy.

  Ease of fitting	4.0 out of 5
  Quality	4.0 out of 5
  Value	4.0 out of 5

• Brian London
  5.0 out of 5

  Good job 12 September 2013

  Good job! Difficult to get tunnel over the vent exit - but managed it by persistence. Simple, cheap, effective.

  Quality	4.0 out of 5
  Value	5.0 out of 5
  Ease of fitting	4.0 out of 5

• Jonnyboy1 Newbury
  5.0 out of 5

  Great bit of kit 07 November 2012

  This is a great method to get a tumble dryer hose through a brick wall. It calls itself a one brick kit but actually only a half brick needs to be taken out. The trickiest part of the job was the drilling. Fitting the kit is really easy. Far better to use this system than to chase out a hole for a circular duct to go through. Very neat and tidy when fully installed. Highly recommended and and excellent service from espares as usual.

  Quality	5.0 out of 5
  Value	5.0 out of 5
  Ease of fitting	4.0 out of 5

• liamh
  5.0 out of 5

  Easy to fit 29 August 2012

  Easy to fit, you only need to remove half a brick which is easier than removing a full one then trying to replace half. Not sure why the hole in the internal wall plate is far bigger than it needs to be, leaving a gap that needs to be filled in.

  Quality	3.0 out of 5
  Value	5.0 out of 5
  Ease of fitting	5.0 out of 5

• Anonymous Milton Keynes
  5.0 out of 5

  Fantastic 24 December 2010

  Recently moved and required a permanent vent kit for our White Knight tumble dryer. This states it is a 'one brick' installation, when it was actually half a brick. Came with an extending tube to fit in the cavity of the wall, all the screw fixings, wall fixings and a new vent hose. Very easy to fit and works fantastically. Excellent value for money.

  Response by Caitlin on 13 Feb 2012

  Please note this product no longer includes the vent hose. Please refer to the photo and product description for further information

  Quality	5.0 out of 5
  Value	5.0 out of 5
  Ease of fitting	5.0 out of 5

• freddyab90 Lymington
  5.0 out of 5

  Very pleased indeed 18 February 2010

  Surprisingly found the wall vent kit very easy to install and I am not a DIY expert by a long way. Came with the vent hose to dryer which I didn't notice in the spec so was an added bonus.

  Response by Caitlin on 13 Feb 2012

  Please note this product no longer comes with the vent hose. Please refer to the product description and photo for further information

  Quality	5.0 out of 5
  Value	5.0 out of 5
  Ease of fitting	5.0 out of 5