Tumble Dryer Square Rear Bearing Bracket Stock Number: ES101583

Overall rating

• Dave Norwich
  5.0 out of 5

  Needed if bearing badly worn 19 January 2016

  You will need a pop rivet gun and a drill to fit this but if the bearing has worn away there's a good chance this will be too so replace the lot in one go. Saves having to strip out the machine again in a short time. Fitted perfectly.

  Ease of fitting	4.0 out of 5
  Quality	5.0 out of 5
  Value	4.0 out of 5

• Tonny Bishop Surrey
  5.0 out of 5

  Probably need if square bearing worn through 01 April 2015

  Had to buy this as the original was worn due to rear bearing failure. You will definitely need a rivet gun to fit.

  Ease of fitting	2.0 out of 5
  Quality	5.0 out of 5
  Value	4.0 out of 5

• Anonymous chippenham
  5.0 out of 5

  Bearing cassing 19 March 2012

  Had fun fitting this one bet working really well now

  Quality	5.0 out of 5
  Value	5.0 out of 5
  Ease of fitting	3.0 out of 5

• ajchilds Nottingham
  3.0 out of 5

  Essential 24 October 2008

  An essiential part when buying the shaft kit, when the black carbon bearing disintigrates, the shaft procedes to grind its way thriugh this part as well, Rivets and a riveter are required for fitting

  Quality	3.0 out of 5
  Value	3.0 out of 5
  Ease of fitting	2.0 out of 5

• philk Cheltenham
  4.0 out of 5

  Phil.Kennerley 23 October 2008

  My tumble dryer of three years finally gave up the ghost so i dismantled it to see what the problems were. I had nothing to loose having never repaired a tumble dryer before.I found the drive belt had snapped due to the rear bearing assembly collapsing. I then ordered the relevant parts from e-spares with replacment back bearing unit, drive belt and front slide bearing assembly. it took me in total about 3hours from finding what the problems were and later refitting the relevant parts

  Quality	4.0 out of 5
  Value	5.0 out of 5
  Ease of fitting	5.0 out of 5

Ratings-Only Reviews