Miele Tumble Dryer Vent Hose - 3m for PT7136PLUS Stock Number: ES503440
High quality vent hose for all models of tumble dryers that require a vent hose with a diameter of 10.2cm
Will this hose fit Bosch model WTV74105GB/12? I have the original adaptor for the machine end but not sure how it fits.. 1 Answer
Please do not publish my email address or location
-
Chris at eSpares says...
This appears to be a suitable replacement for the original hose Stock Number: ES1227249
-
Chris at eSpares says...
We think it will just check the diameter of the inside is 4 inches.
-
Chris at eSpares says...
Yes if you have the adaptors to accept a 4 inch vent hose.
I have thrown away the previous hose as I thought it was faulty as it did not fit the hole in the wall. I now realise that the connector part broke and it is not part of the hose. I am assuming that it is part of the wall fitting. Can I buy it as a separate piece?
-
Chris at eSpares says...
See Stock Number: ES509977 and Stock Number: ES1623344
will this hose fit an indesit IDV 65 tumble dryer and does it need any other connecting part 1 Answer
-
Chris at eSpares says...
You will need Stock Number: ES802589 to connect the hose to the machine.
-
Chris at eSpares says...
It is easy to cut through the plastic wall of the hose but the reinforcing wire that spirals along the length will need cutting. Use the cutter on a combination pliers or a set of side cutters.
Is it simple to detach the original hose from the Adaptor and refit to a new Universal hose - if the Universal hose is supposed to fit a Creda T522VW
- Easy to fit with a little patience
I have been given a White Knight Sensordry Tumble dryer(WK447) without a hose. do i need some kind of connection to fit a new hose on to the back or does it just slip on? thank you 1 Answer
- I have the original piece that fits into the back and the hose will slot into this. However if you don;t have that piece you will need something to affix it to the dryer.
I have just bought a White Knight 447WV drier which has a venting hose already attached at the back with a square flange fitted to the loose end. Unfortunately the hose is too short so how do I lengthen it? Can I attach an extension hose to the fitted o 1 Answer
- Very hard to get a 4" pipe into another 4" pipe i tried as i put mine out the window in the garage, you did not say how long you needed? mine was 3meters long if yours is shorter get one from e spares they are cheap. failing this look for a piece of pipe b&q or building supplier slightly smaller and use a hose clip from halfords to do up each end. hope this helps mike H.