Indesit Tumble Dryer Thermostat Kit for G75C Stock Number: ES487865
Genuine spare part for select Ariston, Creda, Crusader, Electra, Hotpoint, Indesit, Jackson and Proline tumble dryers
I've checked the parts were suitable, rechecked the installation but I'm still not getting heat. What could be the solution?
-
Caitlin at eSpares says...
Considering you've replaced both above parts it could be a fault with the timer. This would need to be looked at by an engineer though as further self diagnosis can be difficult.
I have replaced both the thermostat and heating element but dryer still blowing cold air only - any other solution - help!
- Just make sure the stats are round the correct way and put them on a test machine to see if a current is passing through (good electrical hardware would help). They could be faulty.
I have a Hotpoint Ultima TDC62p Logic Sensing Condenser Tumble Dryer. The Drying light is continually on and the heating elements do not seem to go on and off as they used to do causing the washing to get very hot. Should I replace the thermostats as show 1 Answer
I have purchased a thermo kit for Crusader dryer-please can you tell me where these units are located on the machine? 1 Answer
Model No;37667 Serial No; 77 101 655
-
Rory at eSpares says...
Hi buster, the thermostats are located on the back panel of the dryer next to the element. There may be a cover over the element and 'stats, but this can be removed by unscrewing.
just fitted new thermostat kit the one with the green dot for a Inesit G75c I watched your video on how to change them took photos of conections put 1 Answer
back together it run ok for about half an hour then went cold again so i tested the thermostats and found the grean one had blown why?
- umm not to sure here try replacing the heating elements. not sure if this will fix your problem
Just purchased new Thermostat kit for my Crusader 3kg Tumble dryer. Have fitted new items correctly but still blowing cold air. Any ideas please ? Terry Smith
-
eSparesMalindi at eSpares says...
Please contact an engineer for help because we cannot give out technical advice unfortunately.
-
Rory at eSpares says...
Hi, fitting this thermostat is a tricky job, and I wouldn't attempt it unless you felt extremely competent at this type of fix-it. It involves removing the rear panel of the machine, and disconnecting the old stats. Don't try if you're not 100% confident!
-
Rory at eSpares says...
Hi Jason. It sounds as if one of the thermostats has gone. Replacing a thermostat is a tricky job; it involves removing panels from the dryer, really getting stuck in. If you're not confident about knowing your way around the inside of a tumble dryer, I'd call a repair man.
i recently bought a new heater element from yourselves for a hotpoint tcm 65a tumble dryer. one of the elements was broken on the old one.fitted new parts and my dryer is still blowing cold air help,the wife is giving me grief
- maybe your thermostat has gone
Hi, My Creda T622CW keeps cutting out after a couple of minutes and wont swith back on for a while. Any suggestions? 1 Answer
-
Rory at eSpares says...
Hi Deling32, check out this page for possible causes and solutions to your problem: http://www.espares.co.uk/advice/tumble-dryers/a/9/117/common-tumble-dryer-faults.html
Will this part fit my appliance?
Check Now