Smeg Fridge Freezer Thermostat K59-L1102 Capillary - 1200mm for FC45RX Stock Number: ES486829
High quality thermostat to fit most two door fridge freezers with automatic defrost.
Hi, will this fit a Waeco camper van fridge? I think the model number is CRP40?
-
Ashleigh at eSpares says...
This item is not listed as being suitable for the model information mentioned
Food begins to thaw in freezer before compressor cuts in and freezes it again. Will a new thermostat cure this? Will this one fit my Beko? 1 Answer
Beko CGA 966S Two door fridge/freezer. Serial No; 0410193802 Class; SN Type: 1
-
Dean at eSpares says...
We believe you will need to test the compressor before suspecting anything else.
I have had a look at the thermostat model in there at the moment and it is WDF28Y-L
-
Chris at eSpares says...
This part cannot be fitted, Your correct part is Stock Number: ES1775472
Fridge does not get cold, no noise from motor, nothing happens when you turn the thermostat control knob, silence.
-
Chris at eSpares says...
The correct thermostat is Stock Number ES208996 If the compressor is cold when touched the thermostat may be faulty.
-
Chris at eSpares says...
This may be suitable but the correct original replacement is Stock Number: ES1247779
Will this part fit my unit.
-
Chris at eSpares says...
This should work correctly but the capillary may be different length. The original part is Stock Number ES871175
-
Chris at eSpares says...
No, your appliance uses a control board Stock Number ES1247946 and a sensor foamed into the insulation that cannot be replaced.
1. Will this part replace the thermostat on my Indesit CAA55 Fridge Freezer? 2. If I switch the power off/on the fridge starts to cool and the radiator at the back goes warm. Then the fridge stops cooling and the radiator becomes room temperature. Does this sound like the thermostat? Any help will be appreciated. Regards George
-
Dean at eSpares says...
We believe it is unlikely to be the thermostat, check the defrost system and whether the compressor is running ok before suspecting anything else.
I have a Proline PC226A and thought Bulb had blown. Changing the bulb did not work. There does seem a slight problem with the temperature where I have to have on 5-6 to get Fridge cold ( Freezer seems ok). Would the thermostat affect the lighting system? 1 Answer
-
Dean at eSpares says...
Hi If there is no light in the fridge and you have changed the bulb it is worth checking the bulb holder, the thermostat would not normally be related to this fault
-
Chris at eSpares says...
A faulty thermostat may cause the motor to stop and not restart when more cold is required. If this is happening then replace the thermostat.