Universal 4-Sided Oven Door Seal Kit - 2m (For Square Corners) Stock Number: ES131929
Cut to size door seal suitable for select sized ovens
Buying oven door seal for a friend, she says hers has square corners so what will fit that oven? 1 Answer
The model is white has an emblemQ/A on it and a code number APM3120
- Have just fitted new door seals to our 18yr old Zanussi. The rubber seal came with four Metal Corner Inserts which after cutting the seal to the instructed length are inserted into the new seal. The same inserts have a tang on the back which locate into a hole at each corner. Easy as falling off a log!!
Will this fit a stoves newhome550Si DLm not sure if that correct it could be 55051 Dlm thank you
-
Rory at eSpares says...
Hi, this seal will fit on all domestic Stoves cooker
-
Rory at eSpares says...
Hi, this can fit on either the door or oven proper, wherever your model's seal in placed.
The seal around my Tecnik oven (model 195/3) is just stretched into place and not held with clips. Would I be able to glue this universal seal on instead?? Thankyou for your advice
-
Rory at eSpares says...
Hi, you can give glue a go, I'd recommend this stuff: http://www.espares.co.uk/part/cookers-and-hobs/p/1092/0/0/0/914819/glass-sealant---310ml.html
if not what kind of glue do i need to fit this? because in the model we have (EKC6049x) the metal clips on the seal are glued to it. thanks
-
Rory at eSpares says...
Hi Punkchef I think user Dadio34 answers this one best so I'll quote him on this: 'You need to cut and angle rubber to size. If clips don't fit corners then you need to drill your cooker. Simple job just take time to measure out.'
- No you need to cut and angle rubber to size if clips dont fit corners then you need to drill your cooker simple job just take time to measure out
Should the seal drop in the middle when the oven gets heated?
- If your seal drops you could have not cut length short enough so there is not enough tension hence the heat will cause the rubber seal to expand and sag
This oven door seal has slightly rounded off corners and the seal doesn't meet at the bottom. There are also two side seals on the outer edges of the cooker casing. Including these two side seals the length of seal required appears to be approx 2.5m. There are four corner clips and six end clips required too.
- The corners are the same as mine the clips will not fit so i drilled my cooker in corners to allow clips to fit
- You will likely have to drill your cooker to accept the clips a good guide comes with pack
Will this fit a Stoves EC500DOa electic cooker. Already had the wrong part delivered elsewhere. Your help please. The seal is for the 500mm model.
- you will have to cut rubber to size and drill your cooker so as to take clips a simple diy job