Washing Machine Pressure Switch Stock Number: ES1248731
Genuine spare part suitable for select models of Beko, Altus and Arcelik washing machines
Manufactured by Beko
(This part fits select models)
Will this part fit my Appliance?
Check this part fits your appliance
Washing Machine Pressure Switch
If the pressure switch fails, the pressure of the water cannot be determined, and the machine will not start. The pressure switch will help ensure that the drum is not under filled or over filled with water, and will prevent potential leaks around the appliance by stopping excess water from entering the drum. With help from eSpares and this replacement pressure switch, you can soon be back to a fully working washing machine - so you can tackle the laundry again in no time!
Genuine spare part suitable for select models of Beko, Altus and Arcelik washing machines.
Please check the suitable model fit list to ensure that this is the correct part for your appliance.
3 Questions and 3 Answers
I have a machine which switches on but it does not click and fill the drum with water; you can hear it humm and water does appear at the drain but in no large quantity. Have checked the water pressure and pipes from filling valves to soap box and all are clear from obstructions. the filling valves read 0.002 on ohm meter - is this a pressure switch failure?
-
eSpares Staff at eSpares says...
The inlet valves should read between 2-4 thousand Ohms so based on yout=r reading the valve needs to be replaced.
We have a beko wma510w it washes but does not spin, it also will not take powder from the draw. 1 Answer
-
Chris at eSpares says...
Check the motor brushes and for more information to diagnose your problem see our video: How to Diagnose Washing Machine Control and Program Problems www.espares.co.uk/advice/7/1793
if I put the machine in the test mode, everything works, full speed spin, heater , water fill and drain and wash in both directions. If I run the machine as normal I.e. spin only , it starts of slowly and does the draining but then stops. If I try any wash cycle , it starts but eventually gets stuck at a stage say continually washing one direction and then the other. The water temp seems ok. It's as if it has got confused. I think it might be the pressure switch. Can you help?
-
Chris at eSpares says...
The pressure switch should only effect filling or emptying and may inhibit spinning until the machine thinks it is empty. Your problem is more likely to be the control board but may require replacement to confirm.
Will this part fit my appliance?
Check Now
