Dishwasher Thermostat Stock Number: ES107138
Genuine spare part for select Bosch, Neff, Siemens and Balay dishwashers
Manufactured by Bosch
(This part fits select models)
Will this part fit my Appliance?
Check this part fits your appliance
Dishwasher Thermostat
If your dishwasher is not heating up properly, you may need to replace the thermostat. Once fitted to your dishwasher you should be able to regulate your dishwasher’s temperature and ensure your dishes are cleaned thoroughly.
Genuine spare part for select Bosch, Neff, Siemens and Balay dishwashers.
Please check the list of suitable models to ensure that this spare part will fit your appliance.
5 Questions and 4 Answers
-
Chris at eSpares says...
For information on this problem see our diagnosis video: How to Diagnose Dishwasher leaking and heating problems www.espares.co.uk/advice/3/2083
My Bosch dishwasher stopped working, showed error code E01 and "water" in the display. I checked the water supply, tilted the machine a few times and it started working again. After a couple of washes it started tripping rcd 3 mins into wash cycle. Runs ok on rinse cycle. Is this the heater, control pcb or thermostat?
-
Chris at eSpares says...
The most likely cause if there is no water in the cabinet base is a faulty heating element.
Model number sgs0922gb/11
-
Chris at eSpares says...
Some dishwashers have a 'turbidity sensor' that checks the draining water for signs of contamination and may then carry out another rinse. If the machine rinses repeatedly it may have a contaminated sensor. Try using a dishwasher cleaner for a couple of cycles empty to try and clear this problem.
Hi, when i turn my dishwasher on it starts normally - ie it pumps out any remaining water. The timer then clicks on, and would normally begin the first rinse cycle. Now however it justs stops at that point and sits there. After about an hour it starts up again and completes the cycle! If i try to move the timer on manually to complete the cycle it sounds as though it is trying to rinse, but there is no water feed. Any ideas? Thermostat failed? Thanks, Huw.
-
Rory at eSpares says...
Hi Huw, I'm guessing there's either a blockage somewhere in the drain system, or failing that, the anti-flood device has become damaged. I'm guessing though, that because the dishwasher starts going after an hour or so, that there's a blockage in the drain system. Basically, the anti-flood device is a float switch, which switches on when the base of the dishwasher is filled with water. It sends a message to the PCB telling it to not let any more water in to the dishwasher. It turns off again once the water level has dropped - which sounds as if is an hour later inside your dishwasher. What I'd advise you to do is remove the lower tray and then the mesh filter guard and filter, clean the filter, and remove any and all blockages. Do the same for the drain hose. Do make sure you unplug the dishwasher first, as well as cutting off the water supply to it. Best of luck!
Hi, I have a Siemens SE64630GB/12 dishwasher. Recently it has started up OK filled with water heated and washed but then stops full of water and with all lights off on the switches. If I wait long enough sometimes it resets and contiues the cycle. Could this be a faulty thermostat or controller. I have stripped and cleaned all pipes, flood switch and check the float switches operate OK. I have checked the on/off switch and inspected the wiring and controller connections. Where do i go next, perhaps the tip!
Will this part fit my appliance?
Check Now
