Washing Machine Door Interlock. ZV446E for IWD71250UK Stock Number: ES548529
Spare part suitable for select models of Indesit, Ariston and Hotpoint washing machines
Will this part fit my Appliance?
Check this part fits your appliance
Washing Machine Door Interlock
Door locks need to be checked on a regular basis to ensure they work correctly. If the door is not locked correctly during the wash cycle, it could lead to water leaks from the machine. The door interlock is an electronic device that provides a time delay of approximately 2 minutes, once the cycle has been completed before the washing machine door can be opened.
If your washing machine will not start, yet the relevant lights appear to be lit on the fascia panel, it could be because the door interlock has failed. If the door closes, and the desired cycle is selected but still no joy - it may well be time for a new interlock.
With help from eSpares, you can soon be back to a safe and fully working washing machine again, so the pile of laundry does not start to stack up for you!
Specification:
- Type: IDC Connections
Important:
- The Door Interlock you receive may look different to the published image as Indesit update this part regularly.
- The lock on your machine may not have any screws locating it - but may have plastic 'bumps' instead. If this is the case carefully push on the bumps with the tip of a screwdriver. This will allow them to slip under the front panel as you slide the lock to one side
Door lock plug and loom for some models: Stock Number: ES1130454
Spare part suitable for select models of Indesit, Ariston and Hotpoint washing machines.
Please check the model fit list to ensure compatibility with your appliance.
40 Questions and 35 Answers
The door lock on my Indesit machine doesn't lock, it appears to have come off at the back of the the panel as there's nothing showing there now! 2 Answers
The model is IWE 81281 but there isn't a catch shown for that number (there are no letters after it) How difficult would it be to fit and how much dismantling is needed?
- I have watched this video and it is not the same machine, there is no retaining ring and the interlock does not have external securing screws holding it in place!
-
eSpares Staff at eSpares says...
The door lock is straightforward just watch the video for help www.youtube.com/watch?v=p14EEa4AYGM just copy and paste into your browser.
The door locks when closed and the timer works, but the door locked indicator light doesn't come on, and the cycle won't start. 1 Answer
Hotpoint Aquarius WF 210
-
Chris at eSpares says...
Check the motor brushes are not worn out as this can be a common problem.
my indsit IWB5123 only starts when i open & close the door a couple of time now it won't start at all please help 1 Answer
-
Chris at eSpares says...
Check the motor brushes and if they are OK suspect the lock.
I have a hotpoint HV7F140 the seal inside the door is not as on video it seems to be fixed. 1 Answer
-
Chris at eSpares says...
The seal is fitted to the front panel with a retaining band Stock Number: ES831870. Carefully look around the lip of the seal and you should locate the tension spring, you can then use a small screwdriver to 'catch' the spring and start to pull it over the seal lip to release it.
To operate the washer drier I need to slam the door quite hard . Could the interlock require replacing ?
-
Chris at eSpares says...
Your description suggests the likely cause of your problem to be a fault door lock.
Will this part fit my appliance?
Check Now
