Whirlpool Dishwasher Error Code F07
It has almost become compulsory to have a dishwasher in a contemporary kitchen, especially if you’re not a fan of doing the dishes after dinner. Just like all home appliances the dishwasher can develop faults and disturb the flow of its performance.
If your dishwasher is showing an F07 error code on the display panel, it’s likely to be a problem with the flow meter monitoring the water in the machine. Follow these steps to help you diagnose your flow meter issue and get your dishwasher doing the after dinner chores again.
The flow meter is fitted in either the water inlet pipe immediately after the water inlet valve or the chamber on the left side of the cavity.
Usually, a fan is turned by the water with a magnet attached, which is sensed by a reed relay to check the amount of water which has entered the machine.
Safety First! Please ensure that you have disconnected the appliance from the mains before starting any repair.
- To access the flow switch, remove the top lid and the left side outer panel. Depending on your model the flow sensor may be in the pipe after the water inlet valve or the plastic chamber on the side.
- Inspect the flow switch for any signs of corrosion that may have caused damage.
If you have done the above, with no sign of damage found, you can replace the flow meter today with the help of eSpares.
With the help of eSpares, you can soon be back to a fully working dishwasher again soon - so you can say goodbye to needing to wash the dishes by hand.